Ametek BPS Series Programming Manual Manuale Utente Scaricare il pdf (Pagina 127)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power

Manual P/N 7003-961 Rev. AA 127

INITiate[:IMMediate][:TRANsient]

The INITiate command controls the initiation of the transient generation or measurement

acquisition trigger system. They cause the trigger system to make a transition from the Idle

state to the Waiting-for-Trigger state. If the trigger system is not in the Idle state, the initiate

commands are ignored.

If both the transient generation and the measurement acquisition trigger systems are

initiated at the same time, the first trigger event that occurs will trigger the measurement

system. The transient system will trigger on the next trigger event. Thus, the measurement

system has a higher trigger priority than the transient system. If the measurement trigger is

generated by a transient event, the acquisition system should be initiated first so it is waiting

for the trigger caused by the transient system.

Command Syntax INITiate[:IMMediate][:TRANsient

Parameters None

Examples INIT

Related Commands ABOR INIT:CONT *TRIG

INITiate:ACQuire [Pi Controller Only]

The INITiate:ACQuire command controls the initiation of the measurements trigger system.

They cause the trigger system to make a measurement from the Idle state to the Waiting-for-

Trigger state. If the trigger system is not in the Idle state, the initiate commands are ignored.

Command Syntax INITiate:ACQuire

Parameters None

Examples INIT:ACQ

Related Commands ABOR INIT:CONT *TRIG

INITiate:CONTinuous

These commands control the transient generator trigger system.

• 1 or ON continuously initiates the transient trigger system.

• 0 or OFF turns off continuous triggering. In this state, the trigger system must be initiated

for each triggered event using INITiate:TRANsient.

Command Syntax INITiate:CONTinuous

Parameters 0|1|OFF|ON

*RST Value OFF

Examples INIT:CONT ON

Related Commands ABOR INIT:CONT *TRG

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 225 226

Nessun commento

Ametek BPS Series Programming Manual Manuale Utente Pagina 127