Ametek BPS Series Programming Manual Manuale Utente Scaricare il pdf (Pagina 100)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual

100 Manual P/N 7003-961 Rev AA

4.20 Source Subsystem - PONSetup

This subsystem will control the initial condition of the power source at the power on state.

Subsystem syntax

[SOURce:]

PONSetup:

ALControl 0|1|OFF|ON Set initial ALC state.

CLOCk INT|EXT Set the the clock source to internal or external

CURRent <n> Set the current limit

FREQuency <n> Set the frequency value

NOUTput ONEPhase|THReephase|LAST

Set the command language

OLOad

[:MODE] CVOL|CCUR Set the over load mode const voltage or const

current

OUTPut

[:RELay] 0|1|OFF|ON Set the state of the output relay

PHASe

[:ANGLe] Set the phase angle relative to external

SENSe INT|EXT Set the voltage sense to internal or external

VOLTage

[:LEVel] <n> Set the voltage level

MODE DC|AC|ACDC Set the voltage mode

VRANge 150|300|400 Set the voltage range

WGRoup <n> Set the wave group to 0...3 [3Pi Controller

Only]

PONSetup:ALControl

This command sets the initial ALC mode to either On or Off at power on.

Command Syntax [SOURce:]PONSetup:ALControl <NRf+>

Parameters 0 | 1 | OFF | ON

Examples PONS:ALC 0

Query Syntax PONS:ALC?

Returned Parameters 0 | 1

PONSetup:CLOCk

This command determines the source of its clock at the power on. if internal, the source

uses its internal clock. if external, a clock source must be supplied on the appropriate input.

Command Syntax [SOURce:]PONSetup:CLOCk <source>

Parameters INTernal|EXTernal

Examples PONSetup:CLOCk INT

Query Syntax PONSetup:CLOCk?

Returned Parameters <CRD>

Related Commands FREQ:MODE

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 225 226

Commenti su questo manuale

Nessun commento

Ametek BPS Series Programming Manual Manuale Utente Pagina 100

Commenti su questo manuale

Prodotti e manuali riguardandi Apparecchiature Ametek BPS Series Programming Manual