Ametek DCS-E 1kW Series Programming Manual Manuale Utente Scaricare il pdf (Pagina 22)

Isolated Analog Programmer Operation DLM-E Series and DCS-E Series

2.3.4 Resistance Programming of Output Voltage

SW1 Switch Settings

SW1-1 ON (1) = 0–5K

291213 1

25 21

Set up for resistance programming of the output voltage as follows:

1. Set SW1-1, V PROG, to ON (1) for 0-5VDC programming range.

2. Connect the external programming resistance, 0-5kΩ, to the ISOLATED ANALOG

PROGRAMMER connector, J4, from Pin-9 to Pin-12.

3. Connect a jumper from Pin-21 to Pin-9 to connect the 1mA current source.

4. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG PROGRAMMER

connector, J4, to Pin-2 to enable remote control.

5. Program the other parameters to the desired limit values.

2-10 M51A Option

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Nessun commento

Ametek DCS-E 1kW Series Programming Manual Manuale Utente Pagina 22